Shd
 
 
 
   

Types of Blenders

   
  Heating / Cooling Mixers

Thermal treatment is provided through a thermal fluid jacket on the mixing vessel. Material is heated or cooled by direct contact with the surface area on the tank walls as the paddles and/or ribbons continuously agitate the material. Based on standard models, our engineers can design a heating or cooling mixer to your specific processing needs.

 
Advantages
  • Cost savings as the thermal treatment is accomplished in the same time and vessel being used for mixing step
  • Accurate control of batch thermal treatment time
  • Good control of end material temperature
   
Atmospheric Mixers (Dryers)  
Conductive heating of materials through a thermal fluid jacket on the mixing vessel will result in a flash evaporation of volatile components such as water or organic solvents as the material agitation or transfer exposes the material to the open space at the top of the mixer. In order to continue to drive the evaporation, the vapor in this free space must be removed either by the assistance of a conventional fan or by convection.
 
  • Low capital cost as the drying is accomplished in the same time and vessel being used for transferring and/or mixing
  • Control of batch drying time
  • Good control of end material temperature
  • Suitable for drying of either water or organic solvents
  • No or low dust generation, reduces chances for dust explosions that can occur in convective type dryers
  • Residence time can be adjusted to allow for the removal of "bound" moisture
   
 
Vacuum Mixers
Similar to atmospheric drying, the vacuum process also reduces the atmospheric pressure within the mixer to reduce the vapor pressure of the water. This allows the evaporation of the volatile component to occur at a lower temperature than at atmospheric conditions. Based on standard models, our engineers can design a vacuum mixer/dryer to your specific processing needs.
 
  • Lower operating temperatures make it more suitable for heat sensitive materials such as pharmaceuticals or materials that melt at higher temperatures at atmospheric pressure
  • Head space in the mixer is filled with vapor that will reduce or eliminate presence of oxygen for oxygen sensitive materials or solvents
  • Batch drying time is infinitely variable depending on the residence time required
   
  Dust Control Pug Mill
These pug mills are widely used for removing dust, the dust material is fed into the mill and the mill is provided with spray nozzles through which water is added to the mill.The dust get mixed with water and the slurry is disposed off.
 
Generally twin shaft pug mills driven with dual motor arrangemnt is used.Available in 25, 50 and 100 TPH model.
 
 
 
 
 
 
 
   
2008 MIKRONS®. All rights reserved.
Shd
LGSHD RBSHD
MIKRONS GROUP RIBBON BLENDER